Should I terminate this print?

[terrypin]

I started a discussion yesterday at
https://www.thingiverse.com/thing:2938921/comments

But can't realistically expect feedback to my latest comment from the USA-based author given the 5 hour time zone difference.

Anyone here able to advise so that I can decide whether to terminate the current print run please?

CuraBeforeSliceTop.jpg

2021-04-02 12.38.29.jpg


EDITED about 90 mins later:

Too late now, but the answer was clearly Yes!Is the reason as I implied, namely that the model should have been rotated 180 degs around the X-axis?

FailureOfTop-1.jpg