Close



Results 1 to 2 of 2
  1. #1

    Ender 3V2 printing issue

    Hello,I am trying to print a fairly simple object yet I keep getting the same issue.As you can see in the pictures the print quality is bad with all the blobs on the vertical part of the print.I have leveled the bed many times and I keep getting this issue. I have also calibrated the esteps. I have replaced the PTFE tube as well.I am printing with Sunlu PLA+. I was printing at 220 but now that I set it at 200 the result is a little bit better but it has not gone away.Please advise on how to fix this.Note: I have 2 Ender 3 V2's and the other printer is printing the same files pretty much perfect.

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,061
    Add Roberts_Clif on Thingiverse
    My first to Prints with PLA I set the temp from 192-196C.

    After replacing hot-end heater and thermister. Now 3D Print from 200-208C using the same PLA.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •