Help troubleshooting

[BlindSherpa]

I have tried a couple different options so far. Changes of temperature for the nozzle as well as the baseplate. At first i was trying to print 15 of these at a time so I thought the layers were getting to cold by the time the nozzle passed back over, but after trying to print just one I am getting the same issue I got from the mass print. Any help or possible troubleshooting would be greatly appreciated.

I am working with an Ender 3 pro. If there are any specific specs or things you want to ask me for more context, please let me know. I am not sure exactly what to add to a post like this.

I have attached a picture of the print, as well as the gcode that i was using for said print. The print takes about 30 minutes so if I take your advice do give me some time to start the print again before getting back to you.

Thank you again.