Close



Results 1 to 5 of 5
  1. #1

    Help ! Creality Cr10 Pro

    Hi - This is my fourth print following a clicking filament drive problem? I cleared the nozzle, made sure the feed tube was correctly inserted into the hot end. It printed the raft good, I think?, then the deformation started to happen? the nozzle even scrapped across the filament ? Any thoughts as to what is going on? Please see pic attached.
    Attached Images Attached Images
    Last edited by bullet11300; 02-07-2021 at 04:00 AM.

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Post the filament are you using and at what temperature are you trying to 3D Print.

  3. #3
    Makerbot PLA 200 degrees

  4. #4
    I am noticing that raft or not the first layer is patchy, not joined in the direction of print.

  5. #5
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    This could note under extrusion, though your raft is looking good.
    Is the print speed or temperature changing during print.

    I started with PLA printing a 192C now printing PLA at 208C

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •