Dual Extruder Upgrade

[3dprint]

Right now I have a MakerBot Replicator 2. The project I am working on requires a dual head extruder, but the Replicator 2 only has a single. I do not wish to buy a new replicator 2x, so I was wondering if I could buy a double extruder and then just install it in place of the single on my Replicator 2. Theoretically, would this work or are there conditions I am not thinking of?

[Roxy]

I don't use MakerBot's... But unless they sell an option for it, my guess is you can't do it. The reason is you need an extra stepper motor port on your electronics to provide power to the additional extruder. You should be able to take a look at your electronics and see if you have an extra port that looks like the ones the X,Y & Z motor are attached to. I'm going to move this down to the MakerBot section where you are more likely to get a good answer.