I cannot get any output from my new AnyCubic Photon Zero - Help please

[thegoodguy]

Hi,

I just bought an ANyCubic Photon Zero (APZ). It was great value at $99 and oportunity to dive into higher definition printing.

With the printer I bought Anycubic's plant-based resin.

I have had three attempy at printing a jewellery project and all atempts have failed completely.

Attempt 1 - Using the default setting for plant-based resin in Photon Workshop
Attempt 2 - Using longer UV curing times
Attempt 3 - Adding a base/raft + longer curing times

These are pics of the last attempt where I had a raft/base because I figured the first two attempt may have been adhesion issues due to the small surfaces in contact with the film/tray.

beginner-01.jpgbeginner-02.jpgbeginner-03.jpg

It's just a mess of poop.

I have tried to attached the Photon Workshop files for attempt-2 and attempt-3, but it seems that these file-types (pw0) are not permitted.

Can anyone offer any insight into what I might be doing wrong?

Many thanks.

[thegoodguy]

I figured out that it's an adhesion issue.