Close



Results 1 to 2 of 2
  1. #1

    Prinitng spokes using Creality LD002r printer

    Hi
    I am new at this, and hope someone can please advise. I am a hobbyist (dioramas), and do not design 3D models.

    I have Creality LD002R printer and havebeen able to print some stuff. (yes, including the Eiffel tower ;-))
    When I try to print something that has spokes, they do not print. I have tried this is 1/35 scale, and also in 1/24th scale.

    I use the default settings which are:
    • Layer Height : 0.05mm
    • Bottom Layer count: 10
    • Exposure time : 9s
    • Bottom exposure time: 50s
    • Light-off delay: 0s
    • Bottom light off delay: 0s
    • Bottom lift distance: 5mm
    • Lifting distance: 5mm
    • Bottom lift speed: 65mm/min
    • Lifting speed: 65mm/min
    • Retract speed: 150mm/min.


    Further to this, I have tried supporting and without supports.

    Please help?
    Thanks
    Richard

  2. #2
    Quote Originally Posted by Call_me_Richard View Post
    Hi
    I am new at this, and hope someone can please advise. I am a hobbyist (dioramas), and do not design 3D models.

    I have Creality LD002R printer and havebeen able to print some stuff. (yes, including the Eiffel tower ;-))
    When I try to print something that has spokes, they do not print. I have tried this is 1/35 scale, and also in 1/24th scale.

    I use the default settings which are:
    • Layer Height : 0.05mm
    • Bottom Layer count: 10
    • Exposure time : 9s
    • Bottom exposure time: 50s
    • Light-off delay: 0s
    • Bottom light off delay: 0s
    • Bottom lift distance: 5mm
    • Lifting distance: 5mm
    • Bottom lift speed: 65mm/min
    • Lifting speed: 65mm/min
    • Retract speed: 150mm/min.


    Further to this, I have tried supporting and without supports.

    Please help?
    Thanks
    Richard
    oh... and I use black resin....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •