Close



Results 1 to 2 of 2

Hybrid View

  1. #1

    Ender 3 skipping a layer

    Hey there. My Creality Ender 3 is working quite well. But every once and a while it seems to skip a layer, like its going up just a little bit to high on the Z axis and its not getting great fusion. These print comes out mostly fine except you can see a slight line and it is very weak at that point. Any ideas? I leveled it before I did my last print and this still happened

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    I had a similar problem rerouting the stepper cables away from the controller as quickly as possible and shielding the controller corrected.

    I used Aluminum foil Duct Tape on the inside of my 3D Printed case then attach a ground wire at the Fan mounting screw.

    EFI Shield.jpg

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •