Close



Results 1 to 2 of 2
  1. #1

    MKS BASE V1.1 Firmware Requests Please ?..

    Hello,I have an Aurora3d Prusa i3 using a MKS Base v1.1 atmega board. I have tried repetier and I can get pretty much everything to work. The only issue is the extruder motor wont run. https://chatrandom.livehttps://topda...com/chatrandom
    https://topdatingwebsitesx.com/camsurf I have verified that the motor does work by plugging it into a different controller port.anyone have the original firmware please?thanksalexsunny
    Last edited by alexsunny123; 12-30-2020 at 11:51 PM.

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Let me take a guess!

    While the printer is stopped the hotbed and hot-end are cool every thing works except the extruder stepper.'

    If this is your scenario then take a step back, if the hot-end is not at least 170C the extruder stepper motor is disabled.
    This is an extruder stepper motor safety feature.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •