Results 1 to 10 of 13
Thread: ATMEGA blew up
Threaded View
-
11-21-2020, 02:02 PM #10
Attaching Cura 15.04.6 images one With and one without Support Images and the estimating Print time.
Cura With.jpg
Cura without.jpg
Cura 3.6.0 without.jpg
Printed Model.jpg
Printed model took a little longer 1hour 32 minutes Without supports.
Actually I printed it without supports.
As you can see there is little flaws near the Holes on edge of the left side.
I have two of these Used Hictop a 3DP11 12volt and a 3DP12 24volt .
In fact there is another used Hictop on E-Bay too bad I do not need or have space for another 3D Printer.Last edited by Roberts_Clif; 11-21-2020 at 02:13 PM.
QIDI Slicer "Plater" is...
04-12-2024, 02:21 AM in QiDi 3D Printer Forum