Close



Page 2 of 2 FirstFirst 12
Results 11 to 17 of 17
  1. #11
    ??????.jpg
    On my prusa I have only ender 3 as an option. I downloaded last version from an official site.
    ??????2.jpg

  2. #12
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    I should have Noted that I am using Prusaslicer 2.3.0 alpha 4

  3. #13
    I got that build of prusa slicer and tested it. I printed XYZ cube with cura and prusa slicer, on cura flow was 150%, on prusa i ajusted it to 150% manualy,here are the results:
    1). Top and bottom are better on prusa slicer, but main problem i have with all prints stays same: there are gaps between walls and i can just put my nail between.
    2) Infill is much better on prusa, on cura it just goes wrong
    3) Walls seems good, but they seem more solid on cura
    Pics(Left is Cura)
    707gB9YBaN0.jpgQ0UKuf0YaYM.jpgRvlJttD7iQs.jpgueoT7JDgSzA.jpg
    Also I reprinted default cat with pre-made g-code, there was no such problem here(exept flow was at 150%)^
    Xz1iylQo66E.jpg

  4. #14
    There are links to both cubes and cat gcodes.
    Can u pls say why there are gaps between walls on all sliced models and why there is no such problem on cat?

    https://wdfiles.ru/jv1x
    https://wdfiles.ru/jv1y
    https://wdfiles.ru/jv1z

  5. #15
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    After printing the Calibration cubes, I do not know where these G-Code came from though they printed in excellent condition.

    If you sliced them with Pruseslicer post your 3MF file will look at your settings.
    Last edited by Roberts_Clif; 11-25-2020 at 08:19 AM.

  6. #16
    Cubes were sliced with cura nd prusa slicers, i didnt get 3mf that time, but i recreated that project:

    https://wdfiles.ru/fj3K

    I see all my files have underextrusion which i can fic and wall gap problems.

  7. #17
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,818
    or you can just set it up as #other# and just tell it the size of your print volume - that's all i did for the sapphire pro.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •