Rubicon 3D Scanner on Kickstarter $199

[crowbar]

http://www.kickstarter.com/projects/...con-3d-scanner

6030b88e96e91c46c66ad7248637db63_large.jpg

Worth the gamble?

He did get 287 backers previously on Indiegogo.
http://www.indiegogo.com/projects/rubicon-3d-scanner

[Sinistros]

on Indiegogo it was $200, on Kickstarter $320 (200 British Pound) !!!

[DrLuigi]

on Indiegogo it was $200, on Kickstarter $320 (200 British Pound) !!!

Probably just a mistake on there end,
Or its like most Indiegoto's he makes the later batches a little more expensive.

But still a very nice scanner instead of the ridicolous 1400 from makerbot.

[Sinistros]

I wrote him a message at kickstarter, I will see what he will answer. I will post the answer here, if I get one

[crowbar]

I wouldn't give them any money. They haven't shown any actual scanning or software. You see a laser show going on. Then you see a 3D rendering of the vase on the laptop. Doesn't add up.

I'm no electronic engineer, but this is a very basic looking PCB.

20131110080851-proto2.jpg

[greatestalive]

What ever happened with the Rubicon 3d scanner? It ended up getting funded, but I haven't really heard anything about it since. Have they shipped out any of their scanners yet? Do they work?

[JMK]

They are expected to start being delivered in the beginning of May, so this should only be a couple of week away. I'll be interested to see what feedback is on these. Will it perform as good as the Digitizer? The price tag is certainly attractive.