Close



Results 1 to 1 of 1
  1. #1

    Help! new to 3D Printing

    printer is an Eryone thinker SE.

    I am very new to 3d printing and cannot figure out what is causing some of my prints to fail while others work fine i've bed adjusted so many times now, and tried doing with supports and without, nothing seems to work, sometimes I get a good print and other times its garbage a lot of these are printed in batches which might be what's causing it, I have no clue though maybe its too much extrusion, if any 3d printer wiz's can look at these pics and tell me what might be wrong and how I can go about fixing it or point me in a direction to somewhere I can get help that would be great thank you.
    Attached Images Attached Images

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •