Close



Results 1 to 4 of 4
  1. #1
    Student
    Join Date
    Nov 2020
    Location
    Oxford, UK
    Posts
    12

    UK Small Bracket

    Would like to get this attached printed.Original in PLA, resolution 0.15.Infill 30-40%
    Attached Files Attached Files
    Last edited by CRMS; 11-03-2020 at 05:26 PM.

  2. #2
    It's unfortunate that you are in the UK and I am in the USA. Shipping from here would take forever and cost far more than the item creation. It appears to be an easy print, some minimal supports required and no complex surfaces. The vertical struts at the corners will be rather weak and will snap off easily if any side force is applied.

  3. #3
    Did you get this sorted ?

  4. #4
    Student
    Join Date
    Nov 2020
    Location
    Oxford, UK
    Posts
    12
    Yes, thanks. Done in UK for a pretty reasonable price.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •