Close



Page 4 of 4 FirstFirst ... 234
Results 31 to 36 of 36
  1. #31
    So I just bought a new heat box which came with a new hot end and nozzle and I do not hear any clicking I noticed this when I was doing the temp tower I could not do it as the filament did not come out fast enough

  2. #32
    Are yopu still able to help me??????

  3. #33
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Yes.

    Print something small and post an image. Or post a photo of your temp tower
    post your slicer name and slicer settings.
    Nozzle size, Layer Height, Hot-end Temp, Bed Temp, Print speed nozzle height above the bed at 1st layer.

    Please note the actual hotend temperature during printing, do you have a parts cooling fan running and at what speed.

  4. #34
    my fan i have turned off and i use cura as my slicer and i have a .4 nozzle size i will run my temp tower tommrow

  5. #35
    Check the XYZ axis

  6. #36
    i have found some people at school that are going to fix but thanks so much for all your help i have learned alot from you Thxs!!!

Page 4 of 4 FirstFirst ... 234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •