Close



Results 1 to 3 of 3
  1. #1

    Book Review | Create, Share, and Save Money Using Open-Source Projects

    Hi all, I had a chance to review a pre-published open source and 3D printing-related book:

    "Puzzled about what exactly open-source is and how it could benefit you? In the book, Joshua M. Pearce, an academic engineer at MTU, explains how the open source movement advances in every sphere of activities, encourages to participate and share in order to save money and gain more in return."



    All links are accurately listed under designated chapters on a special page on appropedia.org.
    https://www.appropedia.org/Create,_Share,_and_Save_Money_Using_Open-Source_Projects

    I wish I knew these software/tools before my 3D printing blogging/vlogging journey. It would save me a lot of time and some money.
    Read the full review on 3DWithUs:
    https://3dwithus.com/create-share-an...ts-book-review
    Last edited by Max Funkner; 10-22-2020 at 01:10 PM.

  2. #2
    One of the best book.

  3. #3
    One of the best books I've ever read. I first found it on one gorgeous project that was created as a library of books. Now I am reading there a book https://freebooksummary.com/the-scar...-analysis-8185 which is not even bad, I advise you to read it too. You might even want to review it too.
    Last edited by realityisillusion; 10-29-2020 at 09:08 AM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •