Results 1 to 1 of 1
-
10-11-2020, 09:16 AM #1
- Join Date
- Oct 2020
- Posts
- 1
noob needing help with ender 5 plus not printing
Hi im completely new to 3d printing and am having some troubles. I have an Ender 5 plus with a microswiss direct drive with hot end upgrade. I did 2 prints just fine when i first set it up then out of the blue it started ramming the bed into the nozzle when i went to level the bed. after updating the bl touch firmware that seemed to go away but now when i got to print after heating up and auto leveling it just sits there and completes the print very quickly without actually moving or printing or doing anything. I have no idea what to do now and would greatly appreciate some guidance here. thanks.
Print not sticking to base plate?
Yesterday, 01:26 PM in General 3D Printing Discussion