Results 1 to 2 of 2

Thread: large blobs

  1. #1

    large blobs

    About every 90 minutes I get a really large blob on my prints. Its so large the next pass knocks it off the print and the print turns out ok. It leaves a small burn mark like inside the letter B in the pic. I upgraded the board from cr10 to cr10s and added the creality aluminum extruder. Im using the chepclub profiles. Any ideas how to correct this?
    Attached Images Attached Images

  2. #2
    There are tons of questions on this forum with no replies . It had something to do with my hotend so i bought a new hotend for $25 and now its printing fine.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts