Results 1 to 4 of 4
-
08-25-2020, 01:32 PM #1
[SOLVED!][CR-10 V1 + BLTouch] Print bed not moving during print?
EDIT: SOLVED!
Hello,
I need some help, and this message board looked like a good place to turn to.
To make a long story short, I recently upgraded my workplace's stock Creality CR-10 V1 with a BLTouch V3.1 ABL.
I flashed Marlin 1.1.9, downloaded from the official Creality website.
I'm now having this problem whenever I try to print a gcode file...
- The printer homes normally without issues, even doing the BLTouch 'safe home' at the center of the bed.
- The printer performs the 9-point ABL procedure without issues.
- The printer returns to Y0 X0 and preheats the nozzle.
- When the nozzle is finished heating, and printing is supposed to start, the printer begins extruding filament in one spot without moving any axis.
Here's a video of the issue: https://youtu.be/GNv9I4lEuuc
Here's what I've tried already, with no success:
- Tried power cycling the printer and trying the file again.
- Tried slicing a different GCode file, with a different model, and even slightly different print settings.
- Changed the start Gcode
- Tried printing without doing the ABL routine.
Anyone have any ideas? Thanks in advance.Last edited by McStebb; 08-27-2020 at 02:41 PM. Reason: Solved
-
08-26-2020, 10:45 AM #2
Try compiling your own firmware and see if it makes a difference. If vanilla Marlin is too hard, Cheetah makes it easy...
https://kay3d.com/pages/editing-and-...r-8-bit-boards
-
08-26-2020, 12:03 PM #3
-
08-27-2020, 01:46 PM #4
I fixed it! I rolled it back to Marlin 1.1.6 and that did the trick. I used the 'official' Marlin+BLTouch build from the Creality website.
Need to design a thumb ... do cad...
10-05-2024, 02:49 AM in 3D Modeling, Design, Scanners