Close



Results 1 to 5 of 5

Thread: layer help

  1. #1

    layer help

    i am new to 3d printing and i have fixed several problems but then a new one pops up i need help badly i dont know what to do

    printer ender 3
    Attached Images Attached Images
    Last edited by crazymonke42; 08-09-2020 at 12:47 PM.

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    It appears by what I see that the Nozzle is too high above the bed and never sticks.

    Now this is only a guess, can you give a more detailed post Of how the mess was created.

  3. #3
    Quote Originally Posted by Roberts_Clif View Post
    It appears by what I see that the Nozzle is too high above the bed and never sticks.

    Now this is only a guess, can you give a more detailed post Of how the mess was created.
    so the first layer was perfect but after that this happened and i have no clue how

  4. #4
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Then we need to get more information to see where to start diagnosing your problem.

    What kind of 3D Printer?
    What slicer?
    What firmware? was the firmware pre-flashed from factory or did you flash firmware, ect.....

  5. #5
    i have a ender 3 my slicer is cura and it printed something i designed

    sorry i took so long school started for me

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •