Close



Results 1 to 4 of 4
  1. #1

    Top of print , quality

    Ender 3

    How to get better top surface quality , what is the problem here ?

    Temp nozzle 200

    Profile 0.28
    Attached Images Attached Images

  2. #2
    sand paper.. This is not injection molding.. that look rather good, top is never smooth like bottom. You may want to reduce the extrusion multiplier by .01 or .02, looks a little over extruded

  3. #3
    Thank You

  4. #4
    Hi DavaX,
    If you use Cura you can switch on "Ironing" in the settings.
    It makes the nozzle go over the top layer again with very little filament extruded.
    On the negative side it adds to the print time.

    Hope this helps,

    Andy

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •