Close



Results 1 to 3 of 3
  1. #1

    Anet A6 Extruder Temperature Problem

    Hello!

    I have been having a problem with my Anet A6 after installing a mosfet on the board. My printer seems like it doesn't receive the gcode info to heat up the extruder. The heated bed works fine and so does the extruder thermistor. I have been able to preheat the PLA and set the temperature of the extruder. However, it doesn't heat up to the desired temperature during actual prints. For example, the LCD would display: 23'/0' for the extruder and 23'/50' for the heated bed. My wiring seems to be correct and with solid connections. I have run some tests to see if the board is fried, but it looks good. What should I do? Was the mosfet wiring wrong?

  2. #2
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    798
    Add Roberts_Clif on Thingiverse
    I would check the extruder Thermister wiring.

  3. #3
    Quote Originally Posted by Roberts_Clif View Post
    I would check the extruder Thermister wiring.
    Thanks for the support. I appreciate it. Anyways, I checked the wiring and it looks good to me. I have no clue what else to do.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •