Im waiting with baited breath for my printer to show up as this is my first venture into the world of printing. Once I have it built and levelled I just wanted to ask if any of you have any specific settings in the Prusa Slicer for the ender 3

Ive managed to work with Cura fine and have all the files into Gcode ready to rock and roll, and later this morning I loaded the prusa slicer, seems like a nice bit of software and it does have creatiality ender 3 in the list. Im presuming what I read that the standard settings pretty much work ok, but just wanted to ask if anybody had to tweak anything.

What I also noticed was I imported a pencil holder that I'm doing for the wife, and in Cura it says 1 day 6 hrs in prusa it says 1 day 17 hours.... but not too sure where I look.
I changed the layer from 1.25 to 2.0 before I sliced to match up the settings with Cura

thanks guys

Ted