Close



Results 1 to 3 of 3
  1. #1

    Prusa Slicer and Ender 3 Pro

    Im waiting with baited breath for my printer to show up as this is my first venture into the world of printing. Once I have it built and levelled I just wanted to ask if any of you have any specific settings in the Prusa Slicer for the ender 3

    Ive managed to work with Cura fine and have all the files into Gcode ready to rock and roll, and later this morning I loaded the prusa slicer, seems like a nice bit of software and it does have creatiality ender 3 in the list. Im presuming what I read that the standard settings pretty much work ok, but just wanted to ask if anybody had to tweak anything.

    What I also noticed was I imported a pencil holder that I'm doing for the wife, and in Cura it says 1 day 6 hrs in prusa it says 1 day 17 hours.... but not too sure where I look.
    I changed the layer from 1.25 to 2.0 before I sliced to match up the settings with Cura

    thanks guys

    Ted

  2. #2
    time calc is wrong in any and all slicers, always a guess and typically will take longer than it says, just the nature of the beast.

  3. #3
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    7,658
    Also the ender 3 is significantly slower than any actual prusa design. So prusa slicer is probably slowing down certain sections to give you better prints - that cura might not be doing.
    Go with prusa :-)

    Also that's a ridiculous amount of time for a pencil holder - got a link to the stl or thingiverse page ?

    Check your number of shells and infill settings.

    An awful lot of 'standard' setting use incredibly dense infill - totally unnecassary.

    Drop the link and I'll run it through simplify3d and see what kind of times trhat gives me.

    Also and this doesn't really make sense, but is how it works - the larger the print the less dense you can make the infill while still getting the same size mesh that a higher infill generates with smaller models.

    It's never made sense to me - but it's something to do with how slicers calculate things.

    ALWAYS generate a preview of your models and run through the print virtually before accepting settings.

    My standard infill settings are: tringular patterna nd 15%
    For large models I can often go down to 10% and for small ones frequently up to 25-35%

    Depends on what it's being used for and what the top surface looks like.

    Also while waiting - go watch a lot of videos on how to make ender 3's work and how to fix all the problems they have.

    Unfortunately you've already ordered it so i can't tell you to buy something else.

    But they've been around a while and there are probably several thousand youtube videos on how to fix each individual issue that might crop up.
    Good luck :-)

    And have a chat with Xayoz, they'll put you straight on how to get the best from the ender and probably save a lot of time and swearing :-)
    Last edited by curious aardvark; 06-29-2020 at 02:28 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •