Results 1 to 2 of 2
-
06-21-2020, 02:21 PM #1
- Join Date
- Jun 2020
- Posts
- 1
First Layer Warping on Heated Bed--What Should I do?
I have a Tevo Tornado and have been experiencing warping on the first layer of my prints. I use a glass bed (no masking tape or glue) and PLA. I also use a bed temperature of 60 degrees and a nozzle temperature of 200 degrees. I have attached a picture of the problem. Does anyone know of anything I can use to fix this?IMG_6630.jpgThank you.
-
06-21-2020, 03:28 PM #2
- Join Date
- May 2018
- Posts
- 561
That is not warping, your starting height, also known as Z offset (the distance the nozzle is from the bed during the first layer of the print), is Too Close to the bed.
What's wrong with this prting?
04-14-2024, 05:15 PM in General 3D Printing Discussion