Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Threaded View

  1. 05-31-2020, 06:29 PM #1
    Azurl
    Azurl is offline
    Student
    Join Date
    May 2020
    Posts
    13

    Problems with wavy structure on flat surface.

    Ever since I swapped filament because I ran out of my Raise3d Premium PLA filament, I got hold of a Prima Creator PLA Pro filament.
    I can't get rid of this problem, and I don't know what's causing it, I've perfectly leveled my bed, prints pop off easily but they stick well during print.
    I've tested raising temperature of nozzle from 210 degrees up to 235 degrees.

    I've attached a picture of it.

    is the filament bad?
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules