Results 1 to 2 of 2
-
05-23-2020, 10:47 AM #1
- Join Date
- May 2020
- Posts
- 1
Tronxy X5SA-400 hitting frame
I have just built the X5SA-400. During auto levelling and manual levelling it goes past the bed and hits the frame. I have double checked everything and cannot see why it is doing this.Any help would be appreciated. https://www.youtube.com/watch?v=qoiK...ature=youtu.beUpdate: The wrong firmware was installed from the factory. Firmware update resolved issue.
Last edited by Tom9999; 05-23-2020 at 04:37 PM.
-
05-25-2020, 03:26 PM #2
One or more of your endstops is either in the wrong place, plugged into the wrong socket or possibly just faulty.
Extruder not feeding during print,...
Yesterday, 01:59 AM in Tips, Tricks and Tech Help