I was lucky enough to get a Flashforge Creator from a friend and am having a tough time getting started. I've tried to level the bed the best I can. With some hairspray I was finally able to get the first layer to stick and my first print is in work.


  1. The software in the manual hasn't been updated in years (ReplicatorG) and I can't get it to install on my PC. I've found some STLs on Thingiverse and downloaded Cura. Unfortunately the Creator doesn't show up in the dropdown. Is there a place that I get the specs for adding the printer manually? Or is there a better slicer solution for such a noob to make slices?
  2. Since this printer is really old, is there any firmware I need to upgrade?
  3. Any general tips for getting the most out of this printer?


Sorry for such basic questions. I'm so new, I don't even know what to search for in Google.