Hi Folks, I'm pretty new at 3D printing, but not forums. I'm hoping to stick around and learn instead of being a one question asking and disappearing type member. So, first, if this post should be elsewhere, please move it. Thanks!

With that all out of the way, please take a look at the pictures. I'm using a Snapmaker and their own 1.75mm PLA. The print as you'll see is kind of stringy along one portion of the print. This is an outside wall. It has also happened on an adjacent wall, but in the center. The first thing I'll try is a different temp. I had this one way to high because I forgot to change it after using some Ninjaflex filament. It printed at 235c and the bed was 40c.

I find it extremely odd that it is only happening at these select locations. Anyone see this problem and have a thought on a corrective action?

20200403_074543_capture.jpg

20200403_094657_capture.jpg