Close



Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    A set of nijaflex damper between the motor and frame will also make the machine almost silent.
    Attached Images Attached Images

  2. #12

    RE: Extruder not working

    I'm curious if this problem was resolved. I have had no issues with my Ender 3 until recently. I have virtually the same symptom, except that I don't even get the first layer printed. As soon as the hot end comes away from the home position, the extruder stepper seems to lock up. I can't even advance the filament manually, although I can while its in the home position. I just changed back from ABS to PLA filament and had some issues with the hot end clogging, but that issue was resolved with new Bowden parts. I, however, still have the original firmware installed and have not, to my knowledge, changed any of the settings. I am using the Creality slicer. I am a relative newby to this technology and don't understand a lot of what's going on. Thanks in advance for any insight.Mike
    Last edited by Electromet; 07-23-2020 at 05:07 PM. Reason: mistype

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •