Close



Results 1 to 7 of 7

Threaded View

  1. #1

    Bad - Monoprice MP Select Mini V2 3D Printer

    Hi all,

    Ive got this printer from the university to finish my robotics project at home (due to the virus).
    I have tried to print out but it seems that at most cases the printer is not extruding properly. I have attached some photos of a few samples.
    I have tried hard to look at some example videos and manual instructions in order to fix this issue.
    I did tried to:
    Adjust the bed level and check with piece of paper, multiple times;
    Clean the nozzle and the filament pathway;
    Adjust the settings of the printer including: layer height, print speed, travel speed, infill density, retraction distance, retraction speed and the temperature of the nozzle/bed.

    Any ideas what else can be causing this issue?
    Its almost like the filament is sliding on the bed.

    In addition: the middle of the bed is slightly higher than all 4 corners. Perhaps what is the issue? If that`s the case, is there a way to solve it?

    Many thanks!
    Arnold

    Printer Link:
    https://www.monoprice.com/product?p_id=21711
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •