Close



Results 1 to 2 of 2
  1. #1

    Ender 3 X axis problem

    The ender 3 has been working well so far, but now when the X-axis moves, it just vibrates in place loudly and doesn't move, after disabling steppers, it moves just fine and smoothly, what could be the issue?

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Could be a bad X-Axis Driver, Could be the Stepper motor V-Ref needs to be adjusted, or a Bad Stepper Motor.

    You could switch the XY Stepper motors to see if the problem moves or remains constant, this will eliminate the Stepper if no change occurs.
    You could measure the V-Ref voltage of all Stepper motor Drivers and post your measurements here for further analyses.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •