Printer's home isn't in the center

[Qurp]

I have a CR-10s pro with an inductive sensor and everything works fine except whenever I home the printer nozzle, the nozzle goes to the top right corner of the bed instead of the center. It does this when I start a new print as well. I don't think this is an issue with cura (which is what I use) because of the fact it goes to the same place regardless of if I am printing or just simply pressing home on the printer. Thanks for reading

[Qurp]

E2C6C776-59E7-42FF-BE0F-67F612D12E21.jpg
image of where my printer thinks the center is:

[BunnyKiller]

are the work area parameters set correctly? instead of the work area being ( lets say 200X200 for example) 200X200, its set at 150X150 and finding a new center... just a thought... btw, what are the coordinates on the screen when its at center?