Close



Results 1 to 4 of 4
  1. #1

    Marlin manual Bed leveling Leveling increment tweaking

    Using a Makerfarm Pegasus 8 which in turn is Using Marlin Firmware 1.x, trying to improve my accuracy and was wondering if there is a way to tweak my setting for the manual leveling process.



    When performing a manual bed level, when i turn the knob the x carriage moves up or down at .5mm increments (I think) is there anyway i can lower the number to .25mm or .1mm.



    Perhaps I'm being anal, but I like to be as close to possible when running the process.

    Thanks

  2. #2
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    710
    Add Roberts_Clif on Thingiverse
    Are you looking for
    #define MBL_Z_STEP 0.025 // Step size while manually probing Z axis.

  3. #3
    ah looks like you also found my post on: http://www.3dprintingforum.us/viewto...p=16113#p16113

    Perhaps, is this line already in the Marlin Config.h or am I adding it? Conversely is there a way to do it via Pronterface and gcode commands?

    I don't like posting every where, but seems like a lot people don't know what I'm asking. or that the solution is so incredibly simple they don't bother

  4. #4
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    710
    Add Roberts_Clif on Thingiverse
    I found it in all versions of marlin 1.1.x that I have programmed for My 3D Printer.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •