Close



Results 1 to 3 of 3
  1. #1

    I can't remove my printins from the new crystal bed

    I've bought a new crystal bed for my Ender 3 because the one that comes with the printer was kind of worn out and not very beautiful. But after my first printing I find it impossible to remove the piece, it's stuck as hell. I've tried everything I've seen on the Internet:- Putting the crystal bed with the piece in the freezer for 15 minutes - Reheating the bed with the plate on- Using a 50% alcohol and 50% water solution to try and remove it- Of course, fist of all, using the scratcherAll of them with no results. Any ideas, please?

  2. #2
    Engineer-in-Training
    Join Date
    May 2018
    Posts
    284
    I use a cake icing spatula. for items that are more than 10mm tall I smack them with the wooden handle of the spatula. For smaller items I smack them with the blade of the spatula so to goes under the first layer.
    Mine looks just like this
    https://www.amazon.com/Ateco-1375-St...%2C393&sr=8-52

  3. #3
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    7,264
    hammer.
    often a sharp tap will knock somethiong loose.

    what's a crystal bed made of ?

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •