Close



Results 1 to 3 of 3

Threaded View

  1. #1

    Stringing issues with nylon

    I have been printing on a Creality 10s with E3d hotend for about 3 months now with decent success using PLA and PETG. I recently started working with nylon because I'm primarily interested in building the toughest components possible for remote solar sites. A few of the prints have turned out great and I'm impressed with how tough it is but any complex shape has had problems with stringing. I have messed with heat settings (between 250-285), retraction(3 mm and 8mm), travel paths, print speed and travel speed faster and slower, coasting on and off. I haven't had a single setting change that has had much of an impact and all of my prints have been unusable or require a ton of cleanup. Any thoughts what I'm missing here?I'm using Taulman 3d alloy 910 HDT and 645 1.75 with .4 nozzle. Both oven dried overnight at 150. TIAsee attached for a test print on the alloy 910 HDT
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •