Hi! I hope I'm posting this in the write sub thread, I'm fairly new to 3D Printing and recently picked up a Ender 3. I've had it for 4 days now and after setting it up troubleshooting it has been a pain. I've managed two successful prints in that time, but the day after those it started having problems again.
I have tried everything online from using adhesive helping tools like hairspray, glue sticks, acetone cleaning the nozzle, cleaning the bed with soap and water, then rubbing alcohol, changing filament, checking for clogs, and leveling the bed about half a million times (might still be off on it but I've ran the whole paper test a few times now). However, every time I go to print, it ends up curling on the nozzle or printing just about the first layer then the layer breaks off and the nozzle just drags it.
As I said, I'm fairly new so it could just be a newbie mistake I'm making somewhere, but I would appreciate feedback.