Close



Results 1 to 1 of 1
  1. #1

    parts are printing at angle, help!!!!

    Printer is printing at an angle in the Y axis. it consistently shifts in the y axis building at an angle overlapping each layer. the belt is tight and the y calibration does not show any deviation when measured over and over again. i've used two different slicers, checked the gcode for anything out of the ordinary but nothing diferent, i'm stumped. anyone that can help fix this problem will be rewarded with joy and happiness in their life.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •