Results 1 to 7 of 7
Threaded View
-
12-11-2019, 01:08 PM #1
- Join Date
- Dec 2019
- Location
- Washington State
- Posts
- 4
Whole process equipment and software advice wanted!
Hello,
I am looking for advice on peripherals, software, and the like.
Good or bad, I have a Snapmaker 2.0 350mm purchased that is set to arrive in February. I will be adding an enclosure and creating a venting system for temperature control and ABS printing. This will be located in a home office.
The printer will be used for micro manufacturing, prototyping, metal casting (lost pla), cnc, laser etching, and even some pcb board etching.
The only software I have used for 3d printing so far is Sketchup and Cura. I have Autocad r14 but need to obtain a 32bit computer to get that running again. I am sure Fusion 360 will be highly recommended but will be off the table until I can justify the price.
I am looking for suggestions for equipment and software to aid in both design and process to get my setup ready for operation when the printer arrives.
Thank you,
Steve
Which 3d printer for small...
Yesterday, 05:24 PM in General 3D Printing Discussion