Hi,
I have an Ender 4 that I have converted to CoreXY with a mod from thingiverse. It looks like this:
3D printer half size.jpg
I replaced the gantry carriages (the blue parts) on it because they were heat-damaged after the the printer was transported in my car (it sat in the sun and the car heated up). Even with the damage, my printer was making halfway decent prints, but I wanted to restore full functionality.
After replacing them though, the prints were much worse. I've never seen anything like it. Here's a pic:
Gantry problem half size.jpg
I'm stumped on this one.
Just FYI, I'm using a Duet 2 controller board with this printer.
Any ideas?
Thanks