Results 1 to 3 of 3
  1. #1

    Need connector make/model/etc for RAMPS board power lines - FOUND

    Can anyone tell me the mfg, model, etc. for the power supply connectors used on most clone RAMPS boards? And maybe a source (Mouser, Arrow, ?). They're the 4-pin connectors (actually sometimes two 2-pin connectors mated up).Thank you.
    Last edited by iras; 11-16-2019 at 03:05 PM.

  2. #2
    Same questions

  3. #3
    It took some searching, but I was able to find these connectors on Newark Electronics (Avnet):

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts