Site Sponsor: CRP Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 11-13-2019, 05:39 PM #1
    iras
    iras is offline
    Student
    Join Date
    May 2015
    Posts
    49

    Need connector make/model/etc for RAMPS board power lines - FOUND

    Can anyone tell me the mfg, model, etc. for the power supply connectors used on most clone RAMPS boards? And maybe a source (Mouser, Arrow, ?). They're the 4-pin connectors (actually sometimes two 2-pin connectors mated up).Thank you.
    Last edited by iras; 11-16-2019 at 03:05 PM.
    Reply With Quote Reply With Quote
  2. 11-16-2019, 12:27 PM #2
    BenSherman
    BenSherman is offline
    Student
    Join Date
    Nov 2019
    Posts
    1
    Same questions
    Reply With Quote Reply With Quote
  3. 11-16-2019, 03:01 PM #3
    iras
    iras is offline
    Student
    Join Date
    May 2015
    Posts
    49
    It took some searching, but I was able to find these connectors on Newark Electronics (Avnet): https://www.newark.com/w/c/connector...%20pin%20screw
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules