Close



Results 1 to 3 of 3
  1. #1

    Uneven extrusion

    This is my first 3D printer and I am still quite new to everything. My problem here is that when I start printing projects, the filament is not coming out evenly. On the bottom left quadrant of the prints, the filament would be coming out perfectly fine, but when it starts going onto the other quadrants, it gets extremely thin. I posted a picture for better clarifications (Please excuse the destroyed tape, I've been messing with it a lot and did not want to keep changing it out.) I am not 100% sure that I am doing wrong, I assumed that it was the bed's height so I tried adjusting it but nothing seems to be working. Could you point me in the right direction?
    Attached Images Attached Images

  2. #2
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    643
    Add Roberts_Clif on Thingiverse
    The Bed is not square with the nozzle, and the nozzle is not extruding the material on one side.

  3. #3
    Student
    Join Date
    May 2019
    Location
    Puglia, Italy
    Posts
    5
    I think the first layer is too thin, so you need to increase the distance between nozzle and bed plate. basically, you have to calibrate better the plate. Try to set a little z offset from the slicer. Otherwise you could buy a 3dtouch.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •