Results 1 to 1 of 1
  1. #1

    Getting it to stick !!

    Someone - don't know who - on some website said
    'set the first layer maximum speed to 5 mm/sec'
    Since I've done this my prints stick to a glass bed like the proverbial to a blanket with no preparation apart from a good clean.
    All the edge curling (I print with ABS) has gone and I've stopped messing about with extruder and bed temperature.
    He deserves a medal.
    Also I used to have a problem with the PTFE tube blocking with filament but that seems to have gone by reducing the retraction to 1 mm.
    Hope this helps.
    Last edited by muddledsteve; 11-05-2019 at 04:52 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts