Long story short I just bought the Ender 3 as a spare printer to prototype on, printers were ok but I hated how soft the bed springs were so I upgraded to stiffer ones (to hopefully not have to level so often). Well tightening them all the way down to get ready for leveling I noticed (becuz my right side the nozzle hits the bed) the X axis bar has droop slop on the right side (non motor side). I tried adjusting the centric nuts and everything to get it to level out with no luck. Is this a just "it is what is is" situation and I should either shorten the new springs or swap back to the original ones to level to the bed the the flaw in the X or is something wrong? All my screws are tight.

Any ideas welcome. I'm lost on how to solve is and just assumed maybe people just deal with leveling the bed to the angle?