Close



Results 1 to 2 of 2
  1. #1

    Adventurer 3 Issue

    Have had lots of good prints over several months, then all of a sudden PLA wont stick to surface, had tried cleaning, glue stick, still nothing.
    Any ideas?

    20190831_185526.jpg

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    6,934
    nozzle is too close to the bed.
    It probably needs calibrating.

    The flashprint software doesn't allow for increasing the z-gap (or if it does, I've yet to find the setting and I've really looked recently).
    With my machines I use simplify3d on I'd just add 0.1 or 0.2 to the z-gap and that would fix it. With my knp, which i use flashprint on, I have to manually adjust the bed calibration - which is annoying.

    But that's what causes that crinkling effect on the first layer, head too close to bed.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •