Close



Page 1 of 2 12 LastLast
Results 1 to 10 of 17

Hybrid View

  1. #1

    Creality Ender 3 extruder nozzle zeros itself off and below bed

    So we don't know what happened, things were working fine and now every time we go to press the Auto-Home feature, the extruder nozzle now zeros itself off and below the bed.

    We've tried playing around with some settings, but were at a wall as to what to do to fix this.

    I've attached a pic of what the extruder does when we Auto-Home.

    Thanks.
    Attached Images Attached Images

  2. #2
    Anyone have any ideas?

  3. #3
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    I would start by resetting the Ender 3 to factory settings.


    M502 ;Restore Firmware Defaults settings.
    M500 ;Save settings to EEProm

    Then I would Check all end-stop switches with a M119 ;End-stop States normal state an when switch is activated.

  4. #4
    We went through the menu and we're not seeing any where to reset to factory settings?

    Thank you.

  5. #5
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    From the Menu it should say something like Restore fail-safe. Then Store settings.

  6. #6
    Quote Originally Posted by Roberts_Clif View Post
    From the Menu it should say something like Restore fail-safe. Then Store settings.
    Ok so we scoured the menus and see nothing in reference to that.

    I've attached pics of our menu setup and none of the options seem to mention a Restore or anything.

    Thanks.
    Attached Images Attached Images

  7. #7
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    It should be under the Control menu,

  8. #8
    Ok thanks, I think I found it now. I just need to have my dad come over and help me level the bed properly again.


    I'll let you know if we have any more issues.

    Thank you!

  9. #9
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    If you have more questions post we will do our best to help you answer them.

  10. #10
    So when we try to click on Store Settings inside of Control, the printer just beeps really loud and doesn’t open any more menus or options.

    Any idea now?

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •