OKAY, so I had issues with my DA VINCI 1.0A which is about 3 years old now. I decided to upgrade my extruder to the E3D V6, this is not a clone. I mounted everything and flashed my printer's firmware to Repetier version 0.92.10. I successfully adjusted the Z offset and performed my first print through Repetier host v2.1.6 using the Cura engine slicer.

These are the settings
- 30mm/s speed
- nozzle temp: 230 Degrees Celcius
- Bed temp: 100 Degrees Celcius
- I used blue painter's tape on the bed
- 20% infill
- 0.2mm layer height

Here are the results:
Attachment 13331Attachment 13332Attachment 13333IMG_1017.jpgIMG_1018.jpgIMG_1016.jpg

As you can see, not very good at the moment. But the layers do seem to be a lot more consistent on the 'Y' side compared to most of my prints using the old stock extruder.

If anyone is able to suggest settings to change, It would be much appreciated!