Close



Results 1 to 1 of 1
  1. #1

    PLZ HELP ender 3 layer problems/hitting print

    got a new glass print bed, but this isn't my first print on it. for some reason the first layer now goes down pretty well and then on about the third layer my ender 3 starts over extruding on infill (not on walls) and then the nozzle starts grinding and bumping the layers that are too high and it just makes a mess. I adjusted the Z tension thinking maybe the nozzle wasn't going high enough, I reset Cura slicer to defaults. adjusted the temp down .. nothing seems to help

    pictures are worth 1000 words so please advise me if you've ever seen these problems and maybe have a solution
    THANKS
    MIKE, I want to print again ! ... well successfully ='(

    setup:
    ender 3 (not pro) glass bed, aluminum upgraded stock extruder
    slicer : cura (reset to defaults) no z hop nothing special
    pla: tianse red 1.75
    Attached Images Attached Images
    Last edited by mikeroxy2019; 06-22-2019 at 05:08 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •