Close



Results 1 to 3 of 3
  1. #1

    help understanding print fail

    Hello everyone,,,I have just purchased an ender 3 and everything is set up, my fist print was going to be something that would aid in future prints, a guide for the filament (https://www.thingiverse.com/thing:2917932/comments) I attempted the print in ABS with a bed temp of 110 and a extruder temp of 230 as slic3r recommends and followed the rest of the settings suggested.as you can see form mobdro lucky patcher kodi the print I stopped around 3/4 in as there seemed little point in continuing can any one offer any suggestions as to what went wrong?Attached Thumbnails
    Last edited by Lincon; 06-12-2019 at 11:33 AM.

  2. #2
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    558
    Add Roberts_Clif on Thingiverse
    Can not find attached photos

  3. #3
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    6,744
    yep no pics.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •